WD-1000M-G (G.hn) Industrial grade PLC adapter
Brief introduction
The product transmits the network signals through the existing power line, not need to wire, where is a socket there is a network. The signal is stable and not be influenced by the obstacles. It is easy to use, just plug and play. It supports 128-bits AES data encryption, can insure the safety of data transmission. It’s stable function, strong anti-interference ability, higher level anti-thunder ability and advanced manufacture technique make the product can meet more demands of the market.
Topology
Specification
Specification | |
Model |
WD-1000M-G(Industrial grade) |
Interface |
1*LAN 10/100/1000Base-TX self-adapt RJ45, |
1*AC220V power interface, support MDI/MDX | |
LED display light |
LAN PLC PWR |
Transmission band |
25,50 and 100MHz and MIMO (based on G.9963) |
Protocol(PHY) |
IEEE802.3,IEEE802.3x, IEEE802.3u G.hn |
Security |
128-AES |
Transmission rate(PHY) |
800Mbps |
Modulation |
OFDM |
Management |
Firmware remote update,support TR-069(optional) |
802.1D Ethernet Bridge | |
802.1Q VLAN | |
Quality of Service(QoS) | |
IGMO(IPv4)Snooping&MLD(IPv6)Snooping | |
Working voltage |
AC 85V-265V 60/50Hz |
Working temperature |
-40℃-80℃ |
Size |
159*65*32mm(L×W×H) |
Weight |
0.28kg |
Working environment |
Working humidity:10%-85% no condense |
Storage humidity:5%-90% no condense | |
Certification |
FCC、CE class B,WEEE,RoHS |
Features
Packet loss rate: less than 0.01% (100 m, 70% load measurement) ;
Support 7 * 24 hours work ;
Have hardware watchdog function ;
PING value is less than 1 ms.
Electrostatic discharge reactance immunity:
The test voltage monitoring unit should be able to withstand: ±6kV Direct discharge ,±8kV air discharge. Discharge time in each sensitive test sites: The positive and negative electrodes 10 times each ,each discharge interval 1s,The test procedure follows B/T 17626.2-2006.
Electrical fast transient bursts (common mode) immunity:
The test voltage monitoring unit should be able to withstand: The voltage between power supply port and ground :±2.0kV,Between signal circuit and earth :±1.0kV,repetition frequency :5KHz,Testing time:1min/time Testing voltage times: The positive and negative electrodes 5times each. The test procedure follows B/T 17626.2-2006.
Surge immunity (impact)
The test voltage monitoring unit should be able to withstand: ±2kV,Time interval between successive pulse :1min/time, testing time: The positive and negative electrodes 5times each. The test procedure follows B/T 17626.2- 2006. (Protection adopts the model of full protection and the varistor connects discharge tube in series )
Vibration defending
Meet TB1433 MX3 level requirements (0~200HZ, 2g accelerated speed, maximum amplitude 7mm),in the Testing process, it demands the interface no looseness, device desoldering and falling.
Contact us
Contact Person:Tony Wang
Tel:+86-512-83670078
Mob:+8618796557601
E-mail:lechensales@vip.163.com